Automatic lock screw machine manufacturers tell you the requirements for automatic lock screws to screws

The birth of the automatic screw machine is to comply with the development requirements of the market. It is the basic factor in automatic development through equipment to improve the efficiency. Usually, the hand-held lock screw machine is locked 50 screws per minute. Traditional electric bbscriber cannot be done, and multi-axis automatic lock screw machine, while locking multiple screws, the efficiency is 2-5 times the traditional equipment, and the traditional equipment is out of way. Of course these equipment It is done within the scope of its use. By understanding the working principle of the automatic locking screw machine, it can be clearly known for its range. Maybe each manufacturer's automatic lock screw machine application is different, non-standard automation equipment, no One set, here we use the new roadmark automatic lock screw machine to use the range in detail so that you can refer to it.

Automatic lock screw machine requirements for screw length

Usually we request, the screw length is more than 1.2 times the diameter of the nut, mainly to prevent flipping during transportation, and the ratio is too small to ensure the quality of the automatic feeding.

In theory, the automatic lock screw machine can be used for any length of screws. Due to the length of the screw, the length of the screw will affect the stability of the transport function, and some too long screws are in the actual production design. Not actually, usually the rich mana automatic lock screw machine satisfies a screw with a total length of less than 30mm. If the product screw is too long, but must use the automatic lock screw machine, it is recommended to replace the screw model

Many manufacturers have increased gaskets on the screws for various reasons, can you use the automatic lock screw machine with the screws of the gasket?

What is not possible, there is a lot of screws with spacers:

1. For the screw that needs to be manually placed, it is not suitable. Here mainly considers the efficiency factor. The design concept of the automatic lock screw machine is automatic feeding, automatic lock payment, the speed of supply is not questionable, but if When you lock, place your gasket, in terms of efficiency, this device lost its original advantage, especially the multi-axis and coordinate, and could not play the value.

2. The spline of the gasket and screws, the type of screw is more, and some of the screws for pads are more suitable for automatic lock screws, similar to several of the following pictures, can be used to use Fu Shida Automatic lock screw machine to improve lock payment efficiency